Bantam Overland Cell Phone Mount | 2007-2018 JK

Bantam Overland Cell Phone Mount | 2007-2018 JK

This installation guide is intended to be used to assist you during the installation of your JK Cell Phone Holder from Bantam Overland.

Tools Required: 

  • Socket wrench
  • 8 mm socket
  • Plastic pry tool

Step 1:

Remove the Trim Insert 

  • Using a pry tool or a small flathead screwdriver, carefully pry out the plastic trim insert from the passenger-side dash handle.
  • Remove the two 8mm screws that secure the dash handle. 

Step 2:

Install Mounting Brackets

  • Slide the mounting brackets over the handle posts.
  • The larger bracket goes on the left side.
  • The smaller spacer goes on the right side. 

Step 3:

Reinstall Dash Handle

  • Align the brackets properly and reinstall the dash handle.

Congratulations on installing your new JK Cell Phone Mount from Bantam Overland! 

Back to blog